Go to CircuitHub
All Collections
Board Specifications
Board Specifications
Help related to bare board fab
+1
19 articles in this collection
Written by
Andrew Seddon,
Melissa Hough,
Chris Denney
and 1 other
What is your minimum hole-to-hole drill clearance?
Written by
Melissa Hough
Updated over a week ago
What are your recommended solder mask expansion values?
Written by
Melissa Hough
Updated over a week ago
Can I have UL markings added to my boards?
UL markings
Written by
Melissa Hough
Updated over a week ago
Specs for slotted through-hole pads
Written by
Melissa Hough
Updated over a week ago
What is your silkscreen to solder mask limitation?
Written by
Melissa Hough
Updated over a week ago
What is your minimum solder dam (sliver)?
Written by
Melissa Hough
Updated over a week ago
The Board Tab
The "Board" tab contains critical information that determines how your board will be quoted and manufactured.
Written by
Melissa Hough
Updated over a week ago
Number of layers equals 0
Using EAGLE if you don't define your stackup properly, the layer count will equal zero
Written by
Chris Denney
Updated over a week ago
What core substrates and materials do we support?
Core substrates, materials
Written by
Robert Avakian
Updated over a week ago
Do you support flex boards?
flex pcbs, rigid flex
Written by
Melissa Hough
Updated over a week ago
Panelization Method
Written by
Andrew Seddon
Updated over a week ago
How should I specify blind/buried holes ?
Written by
Andrew Seddon
Updated over a week ago
Why do you only support ENIG finish?
Written by
Andrew Seddon
Updated over a week ago
How should I specify impedance control requirements ?
Written by
Andrew Seddon
Updated over a week ago
What should I enter into 'Custom requirements' on the board view?
Written by
Andrew Seddon
Updated over a week ago
Via In Pad / Active Pad
Written by
Andrew Seddon
Updated over a week ago
Custom stackups
Written by
Andrew Seddon
Updated over a week ago
PCB Capabilities & Design Rules
Written by
Andrew Seddon
Updated over a week ago
Standard stackups
Written by
Andrew Seddon
Updated over a week ago